Lithium Ion Polymer 3.7v Rechargeable Battery 2500mAh 2-pin JST-PH connector by Atomic Market
2-pin JST-PH connector
1.96 X 2.36 X 0.30 inch in size. (7.8x50x60mm)
Built In Circuit Protection at 3.0V. Lithium ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light and powerful. The output ranges from 4.2V when completely charged to 3.7V. This battery has a capacity of 2500mAh for a total of about 10 Wh.
The included protection circuitry keeps the battery voltage from going too high (over-charging) or low (over-use) which means that the battery will cut-out when completely dead at 3.0V. It will also protect against output shorts. However, even with this protection it is very important that you only use a LiIon/LiPoly constant-voltage/constant-current charger to recharge them and at a rate of 1200mA or less. Like most lipos, the batteries we sell do not have thermistors built in. This is why we suggest charging at 1/2C or even less - 1200mA max in this case. Even 500mA is a good charge rate, which is how much you can get from a USB port.
We Also Recommend
1 Channel 5V Relay Module Low level for SCM Household Appliance Control Compatible With Arduino by Atomic Market
2.54MM 6Pin 8Pin 10Pin 10MM Long Needle Female Pin Header Strip Stackable Header Compatible With Arduino by Atomic Market
20CM Male To Male Jumper Wire- Cable 40PACK Compatible With Arduino by Atomic Market
3.3V/5V MB102 Breadboard Power Supply Module Compatible With Arduino by Atomic Market